| CPC F42B 3/006 (2013.01) [B64C 1/00 (2013.01); F15B 15/19 (2013.01)] | 19 Claims |
|
1. A pyrotechnic latch retraction mechanism for a device with wings, including a piston-cylinder assembly, an electric igniter assembly and a guide assembly, Wherein:
the piston-cylinder assembly: includes a piston pin, a cylinder, a first rubber gasket, a second rubber gasket and a pin:
the piston pin is the part that directly holds the device's wings in a folded state,
the piston-cylinder assembly has a step-shaped cylinder and a stepped hole inside the piston-cylinder assembly to make a path for a flow of combustion product gas when an electric igniter of the electric igniter assembly is activated, a first part of the stepped hole is threaded to connect to a mounting bracket, on a body of the piston pin, there are first and second holes drilled perpendicular to the stepped hole, the first hole is machined to connect with the stepped hole at a final position to create a path for the flow of combustion product gases to escape to the cylinder, the second hole is a smooth cylindrical hole used to fit pin and positioning between the piston pin and cylinder;
the cylinder acts as a chamber containing the combustion product gas flow, has a stepped cylindrical shape, and an inner surface that is machined into a smooth cylindrical hole, on an outer surface of the cylinder body, there is a flat milled surface to facilitate the machining of threaded holes to install the pin wherein a position of the threaded hole on the cylinder body and a position of the smooth cylindrical second hole on the piston pin is calculated depending on specific requirements of the device to ensure the latch retraction mechanism works correctly;
the first rubber gasket and the second rubber gasket are to ensure tightness for the latch retraction mechanism, the first rubber gasket is assembled into a groove on the cylinder body, and the second rubber gasket is assembled into a groove on the piston pin;
the pin is used to locate and fix a relative position between the piston pin and the cylinder before operation;
the electric igniter assembly includes the following parts: the mounting bracket and the electric igniter;
the mounting bracket carries the electric igniter and is connected to the piston-cylinder assembly with a threaded joint, the mounting bracket has a stepped cylindrical axial cross-section, with threads on both outer and inner surfaces, the threads on the outer surface are used to assemble with cylinder, the threads on the inner surface are used to assemble with the electric igniter;
the electric igniter contains a pyrotechnic dose inside to create a flow of combustion product gas on ignition that causes the piston pin to move inside cylinder
the guide assembly includes a guide tube, a housing and a bushing;
the guide tube has a smooth cylindrical inner surface and tapered outer surface, when the piston pin moves, the guide tube fits and adheres tightly to the bushing, the outer surface also has threads at the top that connect to the piston pin; the housing is a tubular rotating part, with two symmetrical cavities cut out through an axial plane through a centre thereof, having internal threads at two ends to connect with the cylinder and the bushing; the bushing acts as a limiter for the piston pin and holds the piston pin tightly at the end of a stroke and has a circular shape, an outer surface is threaded to connect with the housing, an inner surface is tapered with a taper angle corresponding to the guide tube.
|